Water line hook up ice maker
Turn the cold water on the supply line clockwise to close it.
Plumb the fridge
Turn on the cold water faucet to drain any water left in the supply line. Keep an extra 8 to 10 feet of water tubing rolled up neatly behind the refrigerator to allow enough tubing to be pulled out if you have to slide the refrigerator away from the wall. Twitter Facebook Pinterest Instagram.
Install the Valve Now that the water's off, install the new valve for the icemaker water line. Thread copper tubing through the hole you just drilled.
If you already have an installed cold water valve behind your refrigerator, all you will need to hook up your fridge to water is some flexible plastic water tubing going from the wall valve to the fridge water inlet valve.
Install the Factory Fill Tube The next step is to install the factory fill tube. Get a water line hook up ice maker empty bucket. Now snake the tubing in backward, starting at the fridge so the coiled portion remains there. You may have to drill a hole through the wall or the floor if needed to get the other end to the water valve. Measure the distance carefully, and buy a supply tube with plenty of length for the job.
Slide on the pressure nut and then the ferrule from the water line kit onto the plastic water line then carefully attach the nut water line to the refrigerator water inlet valve. Holmes and Holmes Tips and How-tos 5 Videos.
Mount the unit to the freezer wall by hanging the icemaker over the mounted screws; making sure to line up the extension tube into the reservoir. Remember, with any plumbing project, once the main water supply is shut off, be sure to shut off the electric heater at the breaker or if it's gas, turn the switch to the pilot position.
Watch for leaks at all the connections. A refrigerator with an automated ice maker and a built-in water dispenser does absolutely nothing if you do not have a water line to connect to it.
Required Tools for this Project
The next step is to install the factory fill tube. But do clamp the tubing to the fridge. Hand-tighten the fitting, then tighten three-quarters of a turn using a small wrench on both sides of the fitting. Next, cut out a small section of the cold water pipe and solder in a copper tee.
To start, locate the cold water source nearest to the refrigerator—perhaps under the kitchen sink, below the floor, in the wall or even in the ceiling. If tightening the connection does not stop the leak, turn off the water, remove the connector and add additional thread-seal tape before reconnecting the water line.
Connect the Supply Tube to the Refrigerator. Imagine the convenience of having cold water or ice cubes any time you want them -- no more filling up pitchers to keep in the refrigerator or waiting for ice cube trays to freeze.
How to Install Kitchen Cabinets 6 Steps. Turn the supply line on once again. Bathroom How Tos 6 Hookup traductor. Let 1 or 2 gallons of water run through the new line to remove the air.
- The dangers of online dating web series
- Dota 2 team matchmaking ladder
- Top mobile dating apps 2015
- Dating someone you dont really like
- Persona 3 portable dating junpei
- Dating she lost interest
- Dating bariatric surgery
- Hi dating sites
- Best free hookup site canada
- Charleston south carolina dating
- What should i do if the girl i like is dating someone else
- Dating a divorced mom
- Best dating profile pics
- Dating an older man for money